Distant Screws II Challenge Coin: Difference between revisions
From Rabbi Blog
m (→About) |
m (→Directions) |
||
| Line 41: | Line 41: | ||
==Directions== | ==Directions== | ||
<youtube>ZYjBJZRjBho</youtube> | <youtube>ZYjBJZRjBho</youtube> | ||
==Visting== | |||
<center>[[File:EvelynsLightPano16_9_smaller.jpg]]<center> | |||
<center>[[Evelyns With Rocky.jpg]]<center> | |||
<center>[[EvelynsDeparting.jpg]]<center> | |||
[[Category:Gaming]] | [[Category:Gaming]] | ||
[[Category:3D Printing]] | [[Category:3D Printing]] | ||
Revision as of 10:12, 4 March 2021
About
- Evelyn's Story
- JelloWiggler's Frontier Forums Thread
- Expedition Page on EDSM
- Evelyn's Light Position on EDSM
ReadMe
A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.
The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.
The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.
Printing Suggestions
Scale to 60mm x 60mm x 8mm (or 10mm)
Super Quality
1) With trees: On an edge - will require sanding and clean up. 2) In halves:
Duplicate the STL on the bed
Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
Flip one of the faces
Print
Glue together
Sand edge as needed with 220g and 500+
Created by RabbiBob 3/1/2021 w/ Blender 2.9.x
Download
- Download: Zip file 4.5MB
Directions
Visting
