Distant Screws II Challenge Coin: Difference between revisions

Revision as of 10:14, 4 March 2021

Heads: Logo + Distant Screws II Jan\Apr 3307 53.2K (light years)

Tails: A star for Evelyn's Light + The expedition route (Ross310 -> Evelyn's Light -> Colonia -> Qama)

About

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.

Printing Suggestions

    Scale to 60mm x 60mm x 8mm (or 10mm)
    Super Quality

1) With trees: On an edge - will require sanding and clean up. 2) In halves:

    Duplicate the STL on the bed
    Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
    Flip one of the faces
    Print
    Glue together
    Sand edge as needed with 220g and 500+

Created by RabbiBob 3/1/2021 w/ Blender 2.9.x

Download

Download: Zip file 4.5MB

Directions

Visting

Arriving solo at 6AM on a cold winter morning

Hanging out with Rocky during the group rendezvous.

One last look at Evelyn's Light before departing the system.

@@ Line 44: / Line 44: @@
 ==Visting==
 <center>[[File:EvelynsLightPano16_9_smaller.jpg]]<center>
+<center>Arriving solo at 6AM on a cold winter morning<br><br></center>
 <center>[[File:Evelyns With Rocky.jpg]]<center>
+<center>Hanging out with Rocky during the group rendezvous.<br><br></center>
 <center>[[File:EvelynsDeparting.jpg]]<center>
+<center>One last look at Evelyn's Light before departing the system.<br><br></center>
 [[Category:Gaming]]
 [[Category:3D Printing]]