Distant Screws II Challenge Coin

Heads: Logo + Distant Screws II Jan\Apr 3307 53.2K (light years)

Tails: A star for Evelyn's Light + The expedition route (Ross310 -> Evelyn's Light -> Colonia -> Qama)

About

• Evelyn's Story
• JelloWiggler's Frontier Forums Thread
  • Where FDev gets involved
  • FDev Delivers
• Expedition Page on EDSM
• Evelyn's Light Position on EDSM

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.

Printing Suggestions

    Scale to 60mm x 60mm x 8mm (or 10mm)
    Super Quality

1) With trees: On an edge - will require sanding and clean up. 2) In halves:

    Duplicate the STL on the bed
    Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
    Flip one of the faces
    Print
    Glue together
    Sand edge as needed with 220g and 500+

---

Created by RabbiBob 3/1/2021 w/ Blender 2.9.x

Download

• Download: Zip file 4.5MB

Directions

Printing

Load video

YouTube

YouTube might collect personal data. Privacy Policy

ContinueDismiss

Painting

• Requirements:
  • Krylon Sandable Primer
  • Gloss Black spray paint
  • Blue acrylic paint
  • Metallic Silver spray paint
  • Something to fit under the coin to keep if off the resting surface (washer, nut, etc)

Primer

• Do two separate coats of prime where the first coat is close to a dusting.

Visting

Arriving solo at 6AM on a cold winter morning

Hanging out with Rocky during the group rendezvous.

One last look at Evelyn's Light before departing the system.